Dimensions Held : Parallelism & TIR HELD TO .003 and available to .001
FEED ROLLER

Choice of Materials/Tradenames/Durometers
NITRILE.......................IMPERIAL TOUCH .....27, 37, 47

Special comments:

This is an excellent replacement for urethane
and zero-crush.

PULL ROLLER

Choice of Materials/Tradenames/Durometers
NITRILE.......................IMPERIAL TOUCH ....27, 37, 47
NITRILE BLEND..........ELEPHANT-HYDE™ ....64, 74, 84

Special Comments:

Our materials are the leaders in corrugated.
Our Elephant-Hyde™ has excellent wear, and grip.
Imperial Touch is the choice for feed rollers.
Available in solid or veneer (dual-durometer) with a
soft base under the non marking material.
Slotting/grooving available.
RA from 50-500 designed to enhance performance.

WIPE ROLLER

Choice of Materials/Tradenames/Durometers
NEOPRENE................SUPREME TOUCH ....55, 65, 72, 82
Special comments:

This roll runs extremely well with a variety of anilox
Rolls with cell counts and volumes
Parabolic and Straight Taper Crowns available

STACKER ROLLER

Choice of Materials/Tradenames/Durometers
NEOPRENE.................SUPREME TOUCH .... 55, 63, 73, 83, 90
EPDM..........................ROYAL TOUCH .... 55, 60, 65, 70, 75, 80
NITRILE.......................IMPERIAL TOUCH .... 27, 37, 47
NITRILE BLEND..........ELEPHANT-HYDE™ 64, 74, 84

BALLAST

Choice of Materials/Tradenames/Durometers
NITRILE.......................IMPERIAL TOUCH .... 27, 37, 47
Special comments:

A soft inner cushion that will yield a higher quality board,
with less warp for more accurate print and registration.
Board production can increase by 10%.
Life of the belts will last up to three times longer.
Tapering available to eliminate edge crush and bounce.

INK ROLLER

Choice of Materials/Tradenames/Durometers
NITRILE BLEND...........FEATHER-TOUCH .... 23, 33, 40
Special comments:

Available as solid or veneer for ink roll in sheet fed.
Ink removal after a run is not necessary as ink can remain
on roller without problems.

EXIT KNIFE ROLLER

Choice of Materials/Tradenames/Durometers
NITRILE BLEND...........ELEPHANT-HYDE™... 64, 70, 74, 80, 84
Special comments:

Non marking material
Our material is preferred internationally for this position.

PRINT CYLINDER

Choice of Materials/Tradenames/Durometers
EPDM............................ROYAL TOUCH .... 71, 76, 81, 86
Special comments:

Royal Touch is ozone resistant.
Replaces wooden and urethane rollers.

AVAILABLE: CERAMIC AND CHROME ANILOX ROLLERS.